Wilo HiControl 1 Flue Control Switch
In stock
Product Code
U72271
Electronic control and regulation accessories. The Wilo HiControl 1 series is used for borehole pumps to enable automatic operation. Wilo-HiControl 1 protects the pump against operation with low volume flow. Thanks to a volume flow sensor and pressure sensor, Wilo-HiControl 1 automates the pump between two values, the start-up pressure and the shut-down volume flow. If the pressure in the network is lower than the start-up pressure, Wilo-HiControl 1 starts the pump. The pump continues to operate until the volume flow falls below the value of the shut-off volume flow.The interior small container prevents water hammering and cycling.
Wilo-HiControl 1 can be mounted on surface pumps or connected to submersible pumps for domestic water supply.
Special features
• Simple installation
• Especially compact design makes it suitable for many types of installation locations
• High operational reliability due to electronic fault signal
• Protection of the connected pumps due to built-in protectionagainst low water levels
• Simple operation due to clear operating state display
• No additional diaphragm pressure vessel required
• Perfect corrosion protection, due to rust-free materials
• Inline version with input and output in vertical axis anduniform thread connections, suitable for direct connection to the pump housing or wall surface installation with a wall bracket (accessories).
Note
• The HiControl 1 may be installed only in vertical position with the output at the top.
Scope of delivery
• HiControl 1
• Cable tie for quick and secure installation of ready-to-plug pump units
Wilo-HiControl 1 can be mounted on surface pumps or connected to submersible pumps for domestic water supply.
Special features
• Simple installation
• Especially compact design makes it suitable for many types of installation locations
• High operational reliability due to electronic fault signal
• Protection of the connected pumps due to built-in protectionagainst low water levels
• Simple operation due to clear operating state display
• No additional diaphragm pressure vessel required
• Perfect corrosion protection, due to rust-free materials
• Inline version with input and output in vertical axis anduniform thread connections, suitable for direct connection to the pump housing or wall surface installation with a wall bracket (accessories).
Note
• The HiControl 1 may be installed only in vertical position with the output at the top.
Scope of delivery
• HiControl 1
• Cable tie for quick and secure installation of ready-to-plug pump units
| Brand | Wilo |
|---|---|
| Manufacturer Part Code | 4190896 |
| Range | HiControl |
| Product Type | Switch |
Collection:
- You can select the branch where you would like to collect your order.
- We will send you an email when your order is ready to be collected.
- Orders received by 3pm can be collected in the branch during opening hours on the next working day if all stock is available in the local branch
- If we need to transfer some of your products from our central warehouse to your local branch, it may take 2-3 days for your order to be ready for collection
- You must report any damages, shortages or incorrect items to the showroom where you collected your order within 48 hours of collection.
Delivery:
- There is a delivery charge of €35 for any order under €500
- You will be contacted by the branch to confirm you delivery details. We will also send you an email to confirm when your order has gone out for delivery.
- Orders received by 3pm can be sent out for delivery during opening hours on the next working day if all stock is available in the local branch and a delivery slot is available. If our normal delivery service schedule is full, you will be contacted by the branch to agree alternative delivery details.
- You must report any damages, shortages or incorrect items to Customer Support within 48 hours of delivery.
Please note you can cancel your order at any time until receipt – see our Returns & Cancellations policy for further information.
